Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS
Before you begin, please check to ensure you have all the parts. Read ALL the directions
before beginning.
CONTENTS
Qty – Description
1 – Main Unit
1 – Extension Pipe
1 – Shower Head
1 – Inlet Fitting
We recommend installing the shower to a solid surface to insure stability and safety.
When using tools, care must be taken not to scratch and/ordamage plating and painting. We
recommend using a cloth between wrench and shower parts to avoid scratching and/or damage.
ASSEMBLING THE SHOWER
1. Locate the 'Showerhead fitting' and wrap 5 to 7 times with Teflon tape provided.
2. Carefully thread the coupler onto the 'Showerhead Fitting' and tighten until snug. DO NOT OVERTIGHTEN. SEE FIGURE 1.
3. Select the shorter end of the extension pipe and wrap 3 to 5 times with Teflon tape provided. Then thread shower head onto
taped end of pipe until snug. DO NOT OVERTIGHTEN. SEE FIGURE 1.
4. Tightly wrap the threads on the remaining end of the extension pipe with Teflon tape 8 to 10 times. Carefully thread wrapped
end of extension pipe into the coupler of the shower until snug. DO NOT OVERTIGHTEN.
NOTE: If the 'Showerhead' is pointing up, simply rotate until it is pointing down.
NOTE: In case of leaks at either coupler from step 1 or 2, remove from fitting, wrap
threading 3 to 4 more times with Teflon tape and reattach. SEE FIGURE 1.
5. Attach a garden hose to the 'Inlet Port' of the shower and a water supply.
SEE FIGURE 3.
6. Match the hot & cold water handle with the
Install the screw to fix the handle. Put the red & blue cover on the hole of the handle.
Please pay attention that the RED part is on left and blue is on right.
MOUNTING THE SHOWER: CONCRETE/MASONRY INSTALLATION ONLY
1. Choose a location for shower that receives the most direct sunlight.
2. Use the main unit to mark the position of the mounting holes to be
drilled into concrete/masonry for bolts. SEE FIGURE 2.
3. Remove shower. Drill
1
/
marks just created.
4. Insert Expansion Nuts into holes. Place the bolt inside the
expansion nut and TAP with a hammer to slightly expand the nut.
5. Remove Bolt and place the base plate/lower tube over the holes
and secure to surface with bolts and washers provided.
NOTE: Base plate will appear loose until shower is fully secured
to the surface.
INITIAL SET UP OF THE SHOWER
1. Turn and lift shower handle to FULL ON HOT position.
2. Turn on water supply to garden hose to fill shower. Shower will take about 2 minutes to fill. NOTE: Filling tube with valve in
hot position ensures no air pockets are trapped in shower. This procedure is used for initial set up only.
3. When water flows from shower head, turn shower handle off. Turning the shower off allows the water to begin heating.
4. Shower is ready to absorb sunlight and heat your water. NOTE: Depending on available sunlight and outside temperature, it
may take up to 3 hours or longer to fully heat the water. Using the shower too soon will yield less heated water. A recently
Qty – Description
1 – Coupler
4 – Expansion Nuts with Bolts
1 – Teflon Tape
quadrate part of the
" diameter holes, 1
3
/
" deep, using the
2
4
blue faucet
FIGURE 1
FIGURE 2
FIGURE 3
Publicité
