i.safe MOBILE IS540.2 Mode D'emploi page 14

CONNECTING APPROVED ACCESSORIES
Only connect accessories approved by i.safe MOBILE GmbH to the device. Accessories
approved by i.safe MOBILE GmbH can be found at www.isafe-mobile.com/en/products
Approved accessories can be connected to any 16-pin ISM interface and to the USB interface.
DANGER
Improper use can result in death or severe injuries! If you need approved accessories in
explosion hazardous areas, please note the following before connecting:
Connect approved accessories to the 16-pin ISM interface of the device only outside of
explosion hazardous areas.
Never open the cover of the 16-pin ISM interface in explosion hazardous areas.
Operate approved accessories in explosion hazardous areas only on the 16-pin ISM interface
of the device. Wired connections via the USB interface are prohibited.
Connect the plug of the accessory securely to the 16-pin ISM interface on the device.
Only remove approved accessories from the 16-pin ISM interface outside of explosion
hazardous areas.
Close the 16-pin ISM interface with the cover provided when you are not using accessories.
16-PIN ISM INTERFACE
Loosen the screw on the 16-pin ISM interface cover using the Screwdriver included in the
approved accessory package. Remove the cover as shown.
Connect the plug of the approved accessory to the 16-pin ISM interface as shown.
Hand-tighten the screws.
Check that the plug is seated correctly and securely.
14