Nacecare Numatic iINTERNATIONAL TTB 2120/100T Mode D'emploi page 7

!
2
Lift top tank assembly to reveal battery compartment.
Always lift between points as illustrated to ensure personal safety (Fig.1).
Fit battery fuse into the battery fuse holder as illustrated (Fig.2).
Remove transit block from pallet (Fig.3).
!
Ensure no metal objects come into contact with battery terminals while the batteries
are exposed. When inserting the fuse you may notice a spark, this is normal.
4
Insert key into ignition and turn quarter-turn clockwise to the 'ON' (1) position, make sure that the
forward / reverse switch is set to forward and the speed control is set to low (Fig.4).
DO NOT depress accelerator pedal while software initialises.
Depress accelerator pedal with right foot and slowly drive machine off of the pallet using the ramp
provided (Fig.5).
Make sure the ramp is central to the machine and drive off straight.
Note: The seat is fitted with a pressure sensor that disables the machine until an operator
is seated.
When the machine is removed and in a safe position, turn key back to the off (0) position (Fig.6).
After the removal of all the packaging, carefully
open and check the contents of the start up pack (Fig.1).
Contents:
1 x Operator Manual
2 x Battery Charger Lead
2 x Keys
1 x 40 Amp Fuse (1 x Spare)
1 x Maxi Fuse-puller
5
Quick Set Up Guide
1
3
7
6
!
!