Publicité
Les langues disponibles
Les langues disponibles
EVO-ONE
EVO-ONE
ALL-IN-ONE DATA INTERFACE
REMOTE STARTER / ALARM
READY MODE
Manual
transmission only
Make sure that
supported on
all doors are
vehicles with door
closed and the
trigger available
transmission is
on the CAN
in the NEUTRAL
network.
position.
DISARM / ENTER / EXIT VALET MODE
STEP 1
to disarm
the system
System
armed :
DEL flash
Insert the
key and
turn it to
to enter and
the ignition
exit valet
(ON/RUN)
mode
position.
System
disarmed :
LED is OFF
COLD START MODE
TO ENABLE
Press and release the FUNCTION button, within 12
seconds simultaneously press and and hold the LOCK and
START buttons for 1 second. The remote's Green LED will
+
flash and beep once to confirm. The parking lights will
flash once.
TO DISABLE
• Press and release the FUNCTION button, within 12 seconds
simultaneously press and and hold the LOCK and START buttons for 1
second. The remote's Green LED will flash and beep once to confirm. The
parking lights will flash twice.
• Put the Remote-Starter/alarm into Valet
• Remote-Start the vehicle
• Open the hood
• Press the brake pedal
• Turn the key to the ignition position.
• Disable Ready Mode (manual transmission).
WARNING
The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of the product, including either
damage to the vehicle itself or to the remote-starter module. This module must be installed by a certified technician including all of the
supplied safety devices. Please note that this guide has been written for trained professional technicians, a certain level of skills and knowledge
is therefore assumed. Please review the Installation Guide carefully before beginning any work.
By default this system is setup for vehicles with a manual transmission. For vehicles with an automatic transmission the safety wire loop on the
main unit must be cut. Before proceeding to the installation, make sure that the vehicle does not attempt to start when the when the vehicle
is in the "drive" or "reverse" position. If an automatic transmission vehicle starts when the transmission is in gear, ensure that the safety wire
loop on the unit is not cut. Once the safety wire loop is cut, the system is considered an automatic transmission remote-starter indefinitely.
Once a loop is cut all warranties, guaranties, and liability is immediately void if the unit is install on a manual transmission vehicle.Neither the
manufacturer or distributor of this module is responsible of damages of any kind indirectly or directly caused by this module, except for the
replacement of this module in case of manufacturing defects. This module must be install by qualified technician. This instruction guide may
change without notice. To download the installation guide, user guide, or the latest quick installation guide, visit: www.fortin.ca
While the
Release the
engine is
brake pedal.
running.
Engage the
parking
brake.
STEP 2
OR
Within 10
seconds
System dis-
press and
armed :
release
3x
LED is OFF
the Valet
3x
switch
or the
antenna
button 3
System dis-
times.
armed and in
valet mode :
LED is ON.
Push the START button
(3 seconds).
The Parking lights will
flash once and then
remain on.
TO DISABLE READY MODE
STANDARD
• Open any door(s)
• Open the hood
Note : If the Parking lights flash 3 times when Remote-Starting, Ready
Mode is not enabled.
REMOTE START / ALARM DIAGNOSTICS
REMOTE STARTER DIAGNOSTICS
Parking lights flashes (before starting) :
3x
Ready Mode disabled
4x
Valet Mode activated (The LED is on)
5x
Hood open
Parking lights flashes (after starting) :
1x
Normal stop (Brake, Park Brake)
3x
Runtime expired or shut down by Transmitter
4x
No tachometer signal
5x
Hood open
6x
Over crank threshold (8 seconds)
ALARM DIAGNOSTICS
Parking lights flashes (after disarm) :
3x
Door open – zone 3
4x
Shock sensor – zone 4
5x
Hood open – zone 5
6x
Trunk open – zone 6
7x
Auxiliary IN– zone 7
Note. : x Indicates the number of times the parking lights will flash.
Technical support:
TEL: 514-255-4357
1-877-336-7797
www.fortin.ca
INSTALLATION GUIDE
Remove the
Exit the vehicle
key from the
and close all of the
ignition barrel.
doors.The Remote-
The vehicle
Starter will stop
will remain
running once all the
running with the
doors are closed.
Remote-Starter.
• Disengage the parking brake
QUICK
RF641W
Publicité
