Axis PEAKnx 2N IP Verso Notice Abrégée page 17

Introduction
Introduction
The following instructions explain how to set up a 2N IP Verso door station with your PEAKnx
touch panel. The communication between the touch panel and the door station is realized
via SIP. Therefore, please make sure that both devices are part of the same network and that
YOUVI has Internet access.
1 Fritzbox Configuration
1.1 Setting up the PEAKnx Panel in the Fritzbox
1. Open the browser, enter "fritz.box" into the address bar and log in to your Fritzbox.
2. Navigate to Telephony > Telephony Devices.
3. Go to "Configure new device", select the option "Telephone" in the next step and go to
"Next".
4. Select "LAN/WLAN (IP telephone)", assign a meaningful name, e.g. "Control 12" and select
"Next".
− Enter the username and password for the PEAKnx Panel and note them for later use. Be
sure to give a secure password.
5. Confirm the assigned phone number and select "Next".
6. Select "Accept all calls" and "Next".
7. You will get an overview, which you can confirm with "Apply". Press any button on the Fritz-
box to confirm the input for the router.
1.2 Setting up the 2N IP Verso door intercom in the Fritzbox
8. Under Telephony > Telephony Devices, go to "Configure new device" again and in the next
step select the option "Door Intercom System" and "Next".
9. The connection is made via "LAN/WLAN (IP door intercom)".
10. Assign a meaningful name for the door intercom and press "Next".
11. Enter a username and password for the door intercom and note them down.
− Be sure to give a secure password.
12. For "Route doorbells to", select "Control 12" from the drop-down list and go to "Next".
− If this option does not appear in the selection menu, you can also select "telephone
number" and enter the phone number "** xxx" of the PEAKnx Panel in the Fritzbox. In this
example, that would be the "** 620".
13. You will get an overview, which you can confirm with "Apply".
17