Simons Voss Technologies SmartBridge Guide Abrégé page 40

9. Reset
9. Reset
Reset system
configuration
40 / 148
If problems should occur or you want to reset the
device to its initial state, you can reset the device with
the reset button.
6
Make a distinction between them:
Reset system configuration: Reset all system

settings (3060 or SmartIntego or MobileKey).
Reset network configuration: Reset all network

settings (IP address, DHCP settings, host name).
NOTE
IP address recovery
If the IP address is assigned by a DHCP server (default
setting), the DHCP server assigns the IP address again
directly after resetting (depending on settings of the
DHCP server).
1. Disconnect the power supply (round plug or net-
work cable for PoE).
2. Wait 20 seconds.
3. Press and hold the reset button.
4. Reconnect the power supply (round plug or net-
work cable for PoE).
5. Release the reset button after one second.
Device flashes green again (see
9
[ 39]
).
}
9 System configuration is reset.
SmartBridge Gateway Node 2
RouterNode 2
Signalling
EN