Home Decorators Collection 489 395 Manuel D'instructions page 6

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
1 Ground Screw (#8)
1 Cross Bar (#11)
INSTALLATION INSTRUCTIONS:
1. Screw the two Mounting Screws (#10) into the Cross Bar (#11). Mount the Cross Bar (#11)
to the Outlet Box (#13) using the two provided Outlet Box Screws (#9). [Make sure the
threads of the Mounting Screws (#10) are facing outside when the Cross Bar (#11) is
attached to the Outlet Box (#13).]
2. Connect the white wire from the fixture to the white wire from the Outlet Box (#13), and
the black wire from the fixture to the black wire from the Outlet Box (#13). Cover the two
wire connections using the two provided Wire Connectors (#12). Wrap the two wire
connections with electrical tape for a more secure connection. If your outlet box has a
ground wire (green or bare copper), connect fixture's ground wire to it using the wire
connector (#12). Otherwise connect the copper ground from the fixture to Ground screw
(#8) on the Cross Bar (#11). Note: If you have electrical questions, consult your local
electrical code for approved grounding methods.
3. Mount the body of the fixture on the wall by aligning the protruding Mounting Screws
(#10) all the way through the holes on the Wall Plate (#5). Be careful not to pinch any of
the wires between the fixture and the Outlet Box (#13). Tighten the fixture to the wall by
screwing the two Lock Nuts (#3) onto the two protruding Mounting Screws (#10).
4. Once the fixture is mounted on the wall, caulk the space between the wall and the upper
3/4 area of the Wall Plate (#5) to prevent water seeping into the Outlet Box (#13). Leave
the bottom 1/4 area un-caulked for drainage of any water which might leak into the
enclosure.
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the
light switch on to activate the fixture.
Page 6
2 Outlet Box Screws (#9)
3 Wire Connectors (#12)
2 Mounting Screws (#10)