Beamz professional IntiBar800 4 Head Barrel DMX Manuel D'instructions page 4

DISPLAY
Display
Addr
Chnd
SLnd
Shnd
SoUn
SEnS
Led
dISP
tESt
hour
uer
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+)
into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
4
When choose a function, press MENU button, select menu options you want.
Press ENTER button to the selected function, the display will be flash, then press
UP/DOWN button to select the required function, press ENTER button, or wait for
10 seconds or press MENU button.
Mode
DMX address setting
Channel mode
Slave mode
Show mode
Sound mode
Sound sensitivity
LED mode
Display inversion
Test mode
Using time of light
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
Function
A001-A512
1 or 10 Channels
Master
Slave 1
Slave 2
Auto SP 1- SP 9
Show mode Sh 0 – Sh 8
Sound on/off
Sound sensitivity 0-100
Display ON-OFF
Led display positive
Self-test
Fixture hours,0 ~ 9999
Software version