Publicité
LED KIT
Start-up
1. Clean the surface you intend to stick the light strip to.
2. Peel off the backing strip off the 3M adhesive tape.
3. Press and hold the light strip firmly against the surface.
4. Remove the tab from the battery compartment of the remote control.
5. Connect the USB cable to the USB port of the desired device .
Changing the remote control battery
The battery for the remote control has already been inserted. You only have to remove the transport guard.
Remote Functions
1.
On/Off switch
2.
White light (RGB mixed colour)
3.
Flash (jump change 7colours)
4.
Strobe (gradual change 3 colours)
5.
Fade (gradual change 7 colours)
6.
Smooth (jump change 3 colours)
7.
Control panel for colour selection (12 mixed colours)
8.
RGB setting (red, green, blue)
9.
Increase/decrease the intensity of colour
1. The battery compartment is located on the narrow side of the remote control. Pull
it out as shown.
2. Remove the empty battery and insert a 3 V battery, type CR2025. The positive
terminal must point upwards.
3. Place the battery compartment back in the remote control so that it locks in
place.
Publicité
