Witter TY146AU Notice De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar
B 1 Right-hand Sidearm
C 1 Left-hand Sidearm
D 6 M10x40x1.25 Bolts, Lock Washers, Flat Washers (30mm O.D) & Spacer Bushes (25 O.D, 9mm Long)
E 4 M12x35x1.75 Bolts, Nuts, Lock Washers and Flat Washers (30mm O.D)
F 2 M12x100x1.75 Bolts and Nyloc Nuts. (Grade 10.9)
ZE 1 Electrical Plate (ZEP2)
For use with either
TY146A Flange neck option – ZF2033. Note: This towbar must be used with either a Witter Towball (part number Z11) or
Class A50-1 or A50-X towball, which dimensionally conforms to A50-1 with a 'D' and 'S' value greater than or equal to that of the
towbar.
TY146AQF Detachable neck option – ZQF2070. Please refer to ZQF fitting instructions for installation
TY146AQ Detachable neck option – ZQ2070. Please refer to ZQ fitting instructions for installation
TY146AS Swan neck option – ZS2070. Please refer to ZS fitting instructions for installation
FITTING
1. Lower Exhaust to identify mounting points on inside faces of chassis rails.
2. Loosely attach sidearms (B) and (C) using fixings (D).
3. Loosely Attach cross-bar (A) to side-arms using fixings (E).
4. Loosely Attach neck option and electrical plate (ZE). Fully Tighten all Fixings.
5. Re-attach exhaust.
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
W0001TY146AU-FIT$010802220000*Ä
W0001TY146AU-FIT$010802220000
TOWBAR
For Toyota Yaris 2006 -
(including eco stop start model)
ZQF2070 ZQ2070 ZF2033
TY146AU
for
TY146A
TY146AQ
TY146AQF
Neck Options
ZS2070