Stop; Economy Mode; Maintenance Plan - Zipper Maschinen ZI-STE3000IV Mode D'emploi

Groupe électrogène
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

11.3.2 Stop

In case of emergency stop the generator directly with the ON-OFF switch
In normal circumstances switch off the generator as follows:
Shut down the connected devices and disconnect them from the generator.
To cool down let the engine running for a while without any loads.
Switch off the generator by putting the engine switch to position „0" OFF
At longer breaks:
To cool down let the engine running for a while without any loads.
Thereafter close the fuel cock by turning to position „OFF".
The engine runs until the remaining fuel is consumed in the carburetor.
Switch off the generator by putting the engine switch to position „0" OFF
11.4

Economy mode

At low power output can be switched with the ECO switch to energy saving mode
ECO switch on: The engine always runs at idle speed and consumes less fuel
At high power output and in DC mode the ECO switch must always be switched OFF
12
MAINTENANCE
No cleaning, upkeep, checks or maintenance when machine is running!
The machine does not require intense maintenance. However, to ensure a long lifespan, we strongly
recommend following the upkeep and maintenance plan.
Repairs must be carried out by specialists! Use original ZIPPER parts only!
Only a properly maintained equipment may be a satisfactory tool. Care and maintenance deficiencies
can cause unpredictable accidents and injuries.
Repairs should be performed only by authorized service centers.
Improper operation may damage the equipment or endanger your safety.
12.1

Maintenance plan

Servicing period
Engine oil
Inspection
(15W40)
Change
Air filter
Inspection
Change
Spark plug
Inspection
Change
Fuel tank /
Inspection
fuel filter
Change
Provide appropriate servicing upon the earlier of the following: in the given month or after the specified
hours of operation (HOO) have expired.
ZIPPER MASCHINEN GmbH
ZI-STE3000IV
Shut off the machine and let it cool down before start servicing!
Before
any
1 month
using
X
X
X
www.Zipper-Maschinen.at
A T T E N T I O N
ATTENTION
NOTICE
After:
After:
3 month
5 HOO
25 HOO
X
MAINTENANCE
After:
After:
6 month
12 month
100 HOO
50 HOO
X
X
X
X
After:
25 month
250 HOO
X
24

Publicité

Table des Matières
loading

Table des Matières