IBM P260 Mode D'emploi page 15

Using the SIZE/CENTER
screen Display
The SIZE/CENTER settings allow you to adjust the
picture's size, centering, or zoom.
Once the setting is adjusted, it will be stored in memory for
the current input signal.
1
Press the button.
The MENU OSD appears.
2
Press the ./> buttons to select "
and press the button again.
The SIZE/CENTER OSD appears.
3
Press the ./> buttons to select the item you want to
adjust.
Select To
adjust the horizontal size of the
(Horizontal Sizing)
picture
adjust the vertical size of the picture
(Vertical Sizing)
(Horizontal Centering) adjust the horizontal centering of the
picture
(Vertical Centering) adjust the vertical centering of the
picture
enlarge or reduce the picture
(Zoom)
On-
SIZE/CENTER"
S I ZE / CENTER
2 6
Customizing Your Monitor
4
Press the ?// buttons to adjust the settings.
To
Select
(Horizontal Sizing) / . . . to increase picture width
? . . . to decrease picture width
(Vertical Sizing) / . . . to increase picture height
? . . . to decrease picture height
/ . . . to move the picture right
(Horizontal Centering)
? . . . to move the picture left
/ . . . to move the picture up
(Vertical Centering)
? . . . to move the picture down
(Zoom) / . . . to enlarge the picture
? . . . to reduce the picture
Press the button once to return to the MENU OSD, and
twice to return to normal viewing. If no buttons are pressed,
the OSD closes automatically after about 30 seconds.
To reset, press the ? (reset) button while the OSD is on.
The selected item is reset to the factory setting.
Note
The (Zoom) adjustment stops when the horizontal or vertical
size reaches its maximum or minimum value. The horizontal
adjustment value is not displayed in the menu.
EN
7