Hatco PW Série Manuel D'installation Et D'utilisation page 11

English
6. Lift the unit, and align the mounting slots on the back of
the unit with the hooks on the wall bracket. Set the unit
securely on the hooks. This step will require at least two
people.
Hanging the Unit
7. Check that the unit is level from front to back. Adjust the
level by turning the leveling studs on the back of the unit,
if necessary.
8. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICATIONS section for details.
Jumper Power Cord
A jumper power cord is available as an accessory that provides
a power connection from one Plate Warmer to another. A total
of three units can be connected together off of one electrical
receptacle. The male plug on the jumper cord connects to
the power outlet on the upstream unit, and the female plug
connects to the power inlet on the downstream unit. Each unit
remains independently-controlled.
Power
Outlet
Power
Cord
Installing a Jumper Power Cord
Form No. PWM-0721
Mounting Mounting
Bracket Hook Bracket Hook
Power Inlet
OPTIONS AND ACCESSORIES
11