Franke TALE 615 W XS Manuel D'utilisation page 10

4. CONTROLS
Button Functions
A
Turns the motor on/off at speed 1.
Speed
Press the button to deactivate any speed.
With the motor turned off:
Saturation of the grease filters takes place after 100
hours of continuous operation of the hood.
With the motor turned off:
Saturation of the activated charcoal filters takes place
after 200 hours of continuous operation of the hood.
B
Turns the motor on at speed two.
Speed
Press and hold the button for approximately 2 seconds,
with all the loads turned off (Motor+Lights), to turn the
Activated Charcoal Filter alarm on.
To turn it off, press and hold the button again for 2
seconds.
C
Turns the Motor on at speed three.
Speed
Press and hold the button for approximately 2 seconds,
with all the loads turned off (Motor+Lights), to reset the
grease and activated charcoal Filter alarm.
D Turns the motor on at Intensive speed. This speed
Speed is timed to run for 6 minutes.
At the end of this time, the system returns automati-
cally to the speed that was set before.
If it is activated with the motor turned off, at the
end of the time the hood will switch to OFF.
Press button D or button A to turn the function off.
E Press briefly: Turns the lighting system on and off at
Light maximum intensity.
5. LIGHTING
• For replacement contact technical support
("To purchase contact technical support").
10
Led
Led A lights up.
-
Flashes once a second.
Flashes once
every 0.5 seconds.
Leds A+B light up.
On: LED (A) flashes twice.
Off: LED (A) flashes once.
Leds A+C light up.
LED A flashes three times.
LEDs A and D light up, but LED D
flashes to indicate that the function
is on.
Led E lights up.