Leonard LK0843 Notice D'utilisation page 19

Problem
Water flows on the
ground.
The temperature in the
appliance is too low.
The temperature in the
appliance is too high.
Replacing the lamp
1. Disconnect the mains plug from the
mains socket.
2. Remove the screw from the lamp cov-
er.
3. Remove the lamp cover (refer to the il-
lustration).
4. Replace the used lamp with a new
lamp of the same power and specifical-
ly designed for household appliances.
(the maximum power is shown on the
lamp cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains
socket.
8. Open the door. Make sure that the
lamp comes on.
INSTALLATION
Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
This appliance should be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the ap-
pliance:
Possible cause
The melting water outlet does
not flow in the evaporative tray
above the compressor.
The temperature regulator is not
set correctly.
The temperature regulator is not
set correctly.
Attach the melting water outlet to
the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might occur for
some types of models when operating out-
side of that range. The correct operation
can only be guaranteed within the specified
temperature range. If you have any doubts
regarding where to install the appliance,
please turn to the vendor, to our customer
service or to the nearest Service Centre
leonard 19
Solution