Aldor Automotive CIT2JYSU Instructions De Montage

Expert III + Traveller 2016-> / ProAce II + ProAce Verso II 2016->
ATTENTION!
To obtain an optimal fixation the ambient temperature during installation should be at least 15°C!
Mounting
1. Check the fit of the spoiler on the car.
2. Use coarse sandpaper to remove the paint on the mounting surface of the spoiler, so that the basic material
becomes visible.
3. Thoroughly clean the mounting surfaces of both spoiler and car with degreaser.
4. Apply the enclosed spoiler glue to the mounting surface of the spoiler (fig. 1).
5. Place the spoiler on the car and position it correctly.
6. Let one person hold the spoiler, so that a second person can carefully open the tailgate. Temporarily fix the
spoiler with tape. Pull the tape from the spoiler around the edge of the tailgate (fig. 2), so that any gaps are
minimised. Any squeezed-out rests of glue must be removed IMMEDIATELY with degreaser!
ATTENTION!

Allow the glue to dry and do not drive the car for 12 hrs. During 24 hrs no mechanical loading should be
applied to the spoiler. Do not wash for 48 hrs.

No warranty acceptance of any damage due to the use of a car wash.
fig. 1
fig. 2
CIT2JYSU-CIT1STSU-OPE2VISU-OPE1ZLSU-PEU2EXSU-PEU1TRSU-TOY2POSU-TOY3POSU.docx-D / Rev. 0
ASSEMBLY INSTRUCTIONS
Jumpy III + SpaceTourer 2016-> / Vivaro C + Zafira Life 2019-> /
Roof spoiler for models with single tailgate with fixed window
Art.nr. : CIT2JYSU
CIT1STSU
OPE2VISU
OPE1ZLSU Zafira Life 2019->
PEU2EXSU Expert III 2016->
PEU1TRSU Traveller 2016->
TOY2POSU ProAce II 2016->
TOY3POSU ProAce Verso II 2016->
Material : PU
Parts list :
Part
Roofspoiler
Tube PU glue
Required tools:
- sandpaper
- degreaser
- tape
glue / Kleber / lijm / colle
Van Hilststraat 4
5145 RL Waalwijk
The Netherlands
tel: +31-416-344 778
fax: +31-416-344 984
www.aldorautomotive.com
Jumpy III 2016->
SpaceTourer 2016->
Vivaro C 2019->
Qty
1
1