Publicité
FEATURES
ES
▶Power: 60W
▶Speeds: 3 levels
▶Fixed or oscillating position
PT
▶security grill
▶Blade diameter: 40cm
▶Adjustable height
EN
▶Silent / Anti-slip
FAN PARTS
1. Front grille
FR
2. Grid Circle
3. Blade holder nut
4. fan blade
5. Grid support nut
6. Rear rack
7. Drive shaft
8. Engine mounting.
9. Control set
10. fixing screw
11. inner tube
12. Height adjustment screw
13. Outer tube
14. Foundation
15. Foundation board
Instruction manual
16. Base security screw
ASSEMBLY INSTRUCTIONS
1. Remove all packaging carefully, avoid scratching plastic
covers with scissors or knives.
2. Assemble the base of the fan, joining it to the lower
telescopic tube.
3. Place on the motor shaft following the following order: the
rear part of the grille, the propeller and the front part of the
grille using the corresponding nuts and washers to hold the
parts together as shown in the upper diagram.
4. To fix both grids use the ring, and fix it with the security
screw.
5. Finally insert the part of the propeller with the motor into
the tube of the telescope and then use the fixing screw to
hold it all together.
6. HEIGHT ADJUSTMENT: Loosen the union thread to insert
the body, once you have defined the desired height, retighten
Ref. 33967
Publicité
