Publicité
Les langues disponibles
Les langues disponibles
3.
SETUP INSTRUCTIONS
Remove any cord wraps and uncoil the cable between the charger and the work light.
3.1
Use the hooks to attach the work light to the underside of the car hood.
3.2
4.
FEATURES
5.
CHARGING
IMPORTANT! CHARGE THE WORK LIGHT IMMEDIATELY AFTER PURCHASE, AFTER EACH USE,
AND AT LEAST EVERY 3-6 MONTHS. Failure to do this will reduce the battery's capacity and may void
the warranty.
Before charging, make sure the work light is turned off.
5.1
Connect the micro USB end of the charging cable to the micro USB port on the work light. Insert the USB end
5.2
of the cable into the USB port on the wall charger.
Plug the AC charger into a live AC outlet.The green LEDs will light, to indicate battery status.
5.3
Charging will take 7-8 hours.When the battery is fully charged, all four LEDs will be lit.
5.4
5.5
When fully charged, unplug the charger from the AC outlet, and then from the work light. The work light is
now ready for use.
Recharge the work light after use, and at least every 3-6 months.
5.6
6.
OPERATING INSTRUCTIONS
IMPORTANT: Charge the internal battery before use.
6.1
Press the Power Level button on the front of the unit:
6.2
1x – turns on one (center) light
2x – turns on two lights
The position of each individual light may be rotated, for more precise positioning.
7.
MAINTENANCE INSTRUCTIONS
After use and before performing maintenance, unplug and disconnect the work light.
7.1
Ensure the work light is unplugged and allowed to cool before attempting any cleaning.
7.2
Any servicing should be performed by qualified service personnel.
7.3
1
1. Hooks for mounting
2. (3) COB LEDs
3. Battery status LEDs
4. Charging port
5. Power level button
Not shown:
• 100-240V AC wall charger with USB port
• Micro USB to USB charging cable
3
3x – turns on all three lights
4x – turns all lights off
• 4 •
2
4
5
Publicité
