Costway NP11183DE Instructions De Montage page 5

13. Note: During use, the blower (air pump) should remain on and
continue to inflate. Since the product is kept inflated by a constant
air flow, air leakage from the joint is normal and necessary, so the
product will not over-expand.
Assembly Instruction
1. Unfold the product in its entirety as the picture shows.
Roll the
Take out the
product and
product
expand it
2. Place the blower (air pump) where it will not inhale dust or
leaves, and keep the blower (air pump) and power cord away
from children and water. Note: Please make sure that the power
supply is safe and reliable. During use, the blower (air pump)
should remain on and continue to inflate. After
stretching the air pipe, position the blower (air
pump) at the end of the air pipe. Wind one end
of the tube around the blower (air pump), blow
out the air after tying. The inflation tube
should be straight and not twisted. If
necessary, adjust the position of the blower
(air pump). Then use ground piles to firmly fix
the blower (air pump) on the ground.
08
Open the Fully expand
product the product
3. Please fix the product correctly, and be sure to fix the product
with ground stakes before use. In order to prevent overturning
during the game, please push the pile firmly into the ground, and
regularly check whether the ground pile is firm. Ground piles
should be flush with the ground or buried in the ground to reduce
the risk of tripping. Please ensure that the
product is fully inflated before children enter
the playground. Using this product when
inflated or excessively deflated may cause
product instability and may cause serious
injury. Since the product is kept inflated by a
constant air flow, air leakage from the joint is
normal and necessary, so the product will not
over-expand.
Maintenance Instruction
Wrong
The product shall be accompanied by maintenance instructions
that draw attention to the need for regular inspection and
maintenance of major components (beams, hangers, anchors,
etc.) and that if these inspections are not carried out, the product
may tip over or otherwise become a hazard. Sometimes
maintenance instructions should also include the following
Right
09