Publicité
®
R&S
ESCU-ZZA
Using the supplied M3x6 screws, secure the R&S ESCU-Z01 Bias Unit (to be
purchased separately) onto the Bias-T rackmount stud rear.
Ensure that all the screws are tightened.
Figure 3-2: Fixing a R&S ESCU-Z01 Bias Unit to the Bias-T rackmount stud rear
A = Details to fix a R&S ESCU-Z01 to the Bias-T rackmount stud rear
B = Bias-T rackmount stud rear fixed with a R&S ESCU-Z01
1 = R&S ESCU-Z01 Bias Unit (to be purchased separately)
2 = Bias-T rackmount stud rear
3 = M3x6 screws (comes with R&S ESCU-Z01 Bias Unit)
2. Using the M5 HEX nuts and screw studs, fix the Bias-T rackmount stud rear
with a R&S ESCU-Z01 Bias Unit
front.
Ensure that all the screws and nuts are tightened.
Figure 3-3: Rear view of the R&S ESCU rackmount kit with a R&S ESCU-Z01 (to be
ordered separately)
1 = Bias-T rackmount stud front
2 = R&S ESCU-Z01 Bias Unit, see
3 = Bias-T rackmount stud rear
Installation Instructions 5602.9960.02 ─ 02
Preparing for rackmount configuration
(Figure
3-2) onto the Bias-T rackmount stud
Table 3-2
Installing the rackmount kit
13
Publicité
