How To Operate - HAEGER Mica Série Mode D'emploi

English

How to Operate

1. With the thermostat control switch in the LOW position and the power set-
ting switches in the "0" position, plug the heater into the main power sup-
ply.
2. Room temperature can be adjusted using the thermostat. Simply turn the
thermostat knob clockwise, to increase the heat, and anti-clockwise to
decrease the temperature, until you reach the desired temperature.
3. Switch the heater to one of the following power settings.
A) MH-060.001A & MH-060.003A:
Turn power switch to (I) position for 300W
Turn power switch to (II) position for 600W
B) MH-120.002A & MH-120.004A:
Turn power switch to (I) position for 600W
Turn power switch to (II) position for 1200W
4. The power switch lights up when activated.
5. Turning the thermostat control clockwise will increase the "set" tempera-
ture.
6. Turning the thermostat anti-clockwise will decrease the "set" temperature.
7. Do not cover the heater at any time during operation. There is a risk of fire
if the heater is covered.
8. Once you have finished using your heater, turn the power switches off, and
the thermostat control switch to the "LOW" position, and unplug from the
mains supply.
IMPORTANT:
When in use, the radiator should always be kept vertical (supports
at the bottom, controls at the top). Any other position could be dangerous!
Cleaning
– Always disconnect the heater from the mains supply before cleaning.
– Clean the outside of the heater by wiping with a damp cloth and buff with
a dry cloth.
– DO NOT use waxes or polishes as these may react with the heater and
cause.
4
(600W max)
(1200W max)
Instructions for use