Publicité
Les langues disponibles
Les langues disponibles
Instructions: Encompass
6. For all RVs
Included with your cover is a toss bag to
help you attach the straps under your
RV. Before you begin, fill your toss bag
with rocks or something of equal weight.
Clip one end of a strap to the buckle on a
tension panel and pass the buckle on the
other end of the strap through the loops
of the toss bag (Fig. 8). Now toss the bag
under your RV to the tension panel on the
opposite side (Fig. 9). Unhook the strap
from the bag and buckle the strap to the
tension panel. Repeat these steps for all
remaining tension panels and straps.
7. If your cover has front or rear tension
panels adjust the strap length across the
front and back to fit your RV. Don't over
tighten—the straps should be snug, not
drum tight.
If your cover has zippered access panels,
the sides of your cover can be unzipped
for access to the doors or storage
compartments. The panels can also be
rolled up and held in place with the rip-
and-grip straps toward the top of each
panel.
Your cover is equipped with extra long
zipper pulls. To secure the zipper pulls so
that they do not drag on the ground bring
the ends of the zipper pulls up and tuck
them into the rip-and-grip closure located
at the base of the zipper along the hem
(Fig. 10).
Use and Storage
To store your cover, roll your cover
up, back to front. Put your rolled up
cover into the storage bag. Pull draw
string tight.
Note: For easier packing and re-installing
fold and roll tightly before packing in
storage bag.
Never store a wet cover in the storage
bag or confined area as the cover can be
damaged by mildew.
Care
Spot clean with water, a mild soap and
a sponge. Don't use abrasive cleaners
or brushes.
Included with the cover is a roll of
adhesive backed fabric. This can be used
either as a reinforcement or to fix a tear.
19cR51_22129
™
Reinforcement: If you notice any
sharp edges during installation cut a
piece of patch fabric and adhere it to
the inside of the cover corresponding
to the location of the sharp edge (i.e.
antennas, drain spouts). Apply pressure
to thoroughly adhere patch.
Fix a tear: Cut a piece of patch fabric to
generously cover the area of the tear.
On the inside of the cover, clean the
area around the tear with water and
mild soap. Dry Completely. Peel off the
backing on the patch and stick over the
tear on the inside of the cover. Apply
pressure to thoroughly adhere patch.
Do not attempt to repair or add
reinforcement if cover is wet.
HINT: Round the corners when cutting
the patch for better adhesion.
CLASSIC ACCESSORIES, LLC
KENT, WA 98032, USA © 2 0 1 9
c l a s s i c a c c e s s o r i e s . c o m
Fig. 7
A
B
B
Fig. 8
Fig. 9
Fig. 10
MILD SOAP
LINE DRY
DO NOT
WATER
IRON
RESISTANT
DO NOT
PACK WET
CLASSIC ACCESSORIES, INC.
22640 68th AVENUE SOUTH
KENT, WA 98032, USA © 2 0 1 6
c l a s s i c a c c e s s o r i e s . c o m
Publicité
