Hisense NB60E-L16BI7 Mode D'emploi page 9

Mounting
Very heavy product; hood handling and installation must be carried out by at least two persons.
Before beginning installation:
Check that the product purchased is of a suitable size for the chosen installation area.
Check (for transport reasons) that there is no other supplied material inside the hood (e.g. packets with screws (*), guarantees (*), etc.),
eventually removing them and keeping them.
If possible, disconnect and move freestanding or slide-in range from cabinet opening to provide easier access to rear wall/ceiling.
for assembling the unit. Cover that surface with a protective covering and place all canopy hood parts and hardware in it.
In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric socket
is available and it is possible to connect a fumes discharge device to the outside (only suction version).
Carry out all the masonry work necessary (e.g. installation of an electric socket and/or a hole for the passage of the discharge tube).
of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Do not
tile, grout or silicone this appliance to the wall. Surface mounting only.
OPERATION
Use the high suction speed in cases of concentrated kitchen vapors. It is recommended that the cooker hood suction is switched on for
5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.
Mechanical controls
Press the Light button to switch the light ON. Press again to switch the light OFF.
Press the Speed 1 button to start the motor with speed 1.
Press the Speed 2 button to start the motor with speed 2.
Press the Speed 3 button to start the motor with speed 3.
Press the Switch Off button to switch off the motor.
Touch controls
When the hood is connected to power supply, the hood will be in standby mode and only On/Off button and Light button will be semi
illuminated. Buttons from Speed 1-3 are not illuminated and not possible to select.
Press the On/Off button to start selecting the motor speeds. When On/Off button is selected, Speed 1-3 are semi illuminated.
Press the Speed 1 button to start the motor with speed 1.
Press the Speed 2 button to start the motor with speed 2.
Press the Speed 3 button to start the motor with speed 3.
Press the Light button to switch the light ON. Press again to switch the light OFF.
09