weltico 65030LB15 Mode D'emploi page 7

NOTE : If the SPOTLIGHT bulb's power is supplied by an electronic transformer there is a risk it may not work (contact your retailer for details).
Works only with a safety transformer (toroidal transformer) Class III 230V / 12V ~.
Provide a power supply 10% higher than the power absorbed by the spotlight.
For example: A power supply of 200 watts provides power for 5 spotlights (12 LED white) :
See the table below to identify the section of cable depending on the length and power. For low currents and short son, please be very superfluous. Remember that falls can be very
high on bad connections, lugs and son Loose oxidized.
Measure the voltage at the end of the cable without the projector (minimum required voltage: 10.5 V / maximum voltage supported: 13.5 V).
6 white LED
2 x 2,5 mm² 13 m
2 x 4 mm² 21 m
For a loss of
0.5 V
2 x 6 mm² 31 m
2 x 10 mm² 52 m
Insert the cable in the grommet at the recess's bottom and leave a sufficient length to be able to pose the spotlight on the pool edge, since the grommet is tightened, the only thing
to do now is to insert the spotlight in its recess.
If the external flexible cable or cord of this luminaire is damaged, it must only be replaced by the manufacturer, its service agent or similarly qualified person, in order to avoid all
risks.
Color LEDs for headlamps
- 10 colours / 5 sequences of linked colours.
- Change of colours or sequences (standard) by disconnection on the power switch "START/STOP".
- Change of colours or sequences by the intermediary of the KIT (optional) Receiver-Controller-Modulator with wireless remote control.
- Keep the pre-defined colour or sequence after the bulb is turned off.
Instructions for use:
When the power is turned on, the bulb lights up. To change the colour or sequence, press START / STOP on the power switch in manual mode. The change procedure requires the
switch to be pressed for less than 1 second.
The first time it is pressed, the bulb initialises on the first fixed colour. Each subsequent time it is pressed, the fixed colours are displayed until the tenth, and then the five linked sequences are
shown until the first fixed colour returns. Pressing for more than 10 seconds leads to memorisation of the current colour or sequence, making it possible to restore the lighting with the pre-defined
colour or sequence.
PRECAUTION : To divide the power supply of the projector before the replacement of the bulb.
1 - Extract the spotlight from its recess and pose it on the pool edge.
1a - Unscrew the 4 screws
1b - Loosen the grommet.
1c - Loosen and remove the six screws to open the assembly.
1d - Unscrew the 2 screws to release the cable.
2 - Change the light bulb and proceed in the reverse order to close the assembly.
3 - Replace the spotlight in its recess.
4 x 36 = 144W.
12 white LED
2 x 2,5 mm² 8 m
2 x 4 mm² 12 m
For a loss of
0.5 V
2 x 6 mm² 19 m
2 x 10 mm² 32 m
INSTRUCTIONS TO REPLACE THE LIGHT BULB
12 LED colors
2 x 2,5 mm² 9 m
2 x 4 mm² 13 m
For a loss of
0.5 V
2 x 6 mm² 20 m
2 x 10 mm² 32 m
EN
1.c
1.b
1.a
1.d