Vonyx VSP200 Manuel D'instructions page 4

17. 12V DC INPUT
Connector for using 12V DC external power supply
18. POWER SWITCH
19. AC IN AND FUSE HOLDER
Socket for plugging in the supplied power cord. For instructions on how to change the fuse, see "REPLACING THE FUSE"
CONNECTING WITH BT
If password is required, you can enter "0000".
Attention: The BT distance is approx. 10 meter without any barrier.
REMOTE CONTROL
1. POWER ON/OFF
Press to turn the device on/off
2. STOP
Press to stop playback
3. MUTE
Press to (un)mute the device
4. MODE
Press to change modes
5. REPEAT
Press to switch between different repeat modes
6. EQUALIZER
Press to change preset equalizer setting
7. PREVIOUS
Skip to the previous track
NEXT
Skip to the next track
8. PLAY / PAUSE
Press to switch between play and pause
9. VOLUME -
Press to decrease the volume
VOLUME +
Press to increase the volume
10. NUM PAD
Direct number input
UHF WIRELESS MICROPHONE
Insert the batteries into the wireless microphone (observe the polarity) and turn all volume controls down. Switch the system to
'ON' and the power led will light. Switch the microphone to 'ON' and set the volume knobs to the desired position.
Take care not to incur feedback from the speaker. Turn the echo and equalizer to a position in order to have the desired sound.
CHARGING BATTERY
Prior to use this system the internal 12V battery needs to be charged for 12 hours. If the power switch is in the 'OFF'-position
and the system is connected to the mains, the battery will be (re)charged and the charge LED will light.
Note: Pull the plug from the mains outlet as soon as the battery is fully charged.
The battery should be regularly charged. For optimal battery life, the battery should be charged at least once a month. Please
note that if you do not load within 6 weeks, the battery could become defective.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the
fuse, unplug mains lead. Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
UHF
No license required
BE DK
HU IT
PT RO
CH GB
Belgium (BE), Denmark (DK), France (F), Finland (FI), Germany (DE), Hungary (HU), Italy (IT), Netherlands (NL), Norway (NO), Poland (PL),
Portugal (PT), Romania (RO), Slovenia (SI), Spain (ES), Sweden (SE), Switzerland (CH), Great Britain (GB)
4
1. Activate the BT-function on your device (Mobile phone, tablet etc.) from which you want to play the
music. See the operating instructions for that device.
Press the "MODE" button and activate BT-function.
2.
Select "VSP200" on your BT-device and make the BT-connection.
3.
(excluding geographical restrictions)
F FI DE
NL NO PL
SI ES SE