Introduction; Supplied Accessories; Symbols Used In This Manual; Attaching The Stand - Emerson LD190EM1 Guide D'utilisation

I
NTRODUCTION
 Supplied Accessories
owner's manual
(1EMN26007)
• If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.
 Symbols Used in this Manual
The following is the description for the symbols used in this manual. Description refers to:
TV FUNCTIONS
: Analog TV operation
TV
: Digital TV operation
DTV
• If neither symbol appears under the function heading,
operation is applicable to both.
 Attaching the Stand
You must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the
proper direction.
1
Spread a thick and soft cloth over a
table as shown below.
Place the main unit face down onto it.
Make sure not to damage the screen.
To remove the stand from this unit
Unscrew the Phillips pan screws indicated by above
➂
" " screw holes. After the screws are removed pull
the stand up toward the rear of the unit. Be careful
not to drop the stand when you remove it.
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.
 Tilt Stand
You can adjust the stand to change the angle of the unit (-2.5° to 10°).
4
EN
quick start guide remote control
(1EMN26008) (NF033UD)
2
Align the 2 stand hooks with the two
hooks under the bottom of the main
unit (shown by arrow
the stand in the direction as shown
➁
by arrow
mounting holes are aligned. Make
sure not to put the AC power cord
between the stand and the unit.
batteries
(AA, 1.5V x 2)
DVD FUNCTIONS
: Playback of DVD-video
DVD
: Playback of audio CD
CD
• If neither symbol appears under the function heading,
operation is applicable to both.
➀
), then slide
until it stops and the 3
screw kit for attaching
the stand
(1ESA23636)
3
Drive Phillips pan screws in the 3
threaded holes at the bottom of the
stand until they are tight.
screw holes
-2.5°
10°