Husqvarna 93013950144C1 Instructions De Montage page 4

Scope of supply
1x brake lever 
NOTE
All screws and nuts from the original lever can be re-used.
Before assembly, these parts must be cleaned thoroughly and, if
necessary, greased.
Assembly
- Remove fi tting  .
- Remove the original brake lever.
- Position brake lever  (included).
- Mount fi tting  and tighten to 8 Nm.
- Adjust the basic position of the handbrake lever to your hand size
by turning setting wheel  .
NOTE
Push the handbrake lever forward and turn the setting wheel.
Do not make any adjustments while riding.
Ensure that the lever is assembled correctly!
Ensure that the brake is functioning correctly before using it for
the fi rst time.
4