Publicité
11
800.633 .5096 |
OPERATING INSTRUCTIONS:
Control panel on the front of the unit:
(5)
(4)
1. POWER
1. On/Off Main Power Button
a.
Press to turn the unit ON/OFF.
b.
The system will load default factory settings when turned on.
c.
NOTE: When the unit is turned off that the logs and flames will slowly die down.
2. Adjustable Brightness
a. Adjust the flame and log brightness level: L5 - L4 - L3 - L2 - L1 (L5 being the brightest and L1 the
dimmest)
3. Heater
a. This allows programming of the thermostat. The fireplace can be used without the heater if desired.
b.
Adjust the temperature rating from 99 (60 )→ 86 (30 )→ 82 (28 )→78 (26 ) → 75 (24 )→
71 (22 ) →OFF
c. Note:
d. The heater display unit switching function, When HEATER already in the open state, long press the
heater button for 5 seconds, the temperature readout will switch directly (° F / ° C).
4. On/Off Down Light Button
a. Turn the down light ON and OFF.
5. Adjustable Timer
a. Timer setting switch: 10min- 20min- 30min- 40min- 50min- 1H- 2H- 3H- 4H- 5H- 6H- 7H- 8H- 9H
Main Display:
ELECTRICAL CONNECTION:
A 12.5 AMP, 120 Volts, 60 Hz circuit with a properly grounded outlet is required. It's recommended that the fireplace be on a
dedicated circuit, as other appliances on the same circuit may cause the circuit breaker to trip or blow the fuse when the
heater is in operation.
se ifu r nitu re store. com
(3)
(2)
2. FLAME AND LOG
for the default units
ELECTRICAL SPECIFICATIONS
Voltage:
Amps:
Watts:
Lighting:
(1)
3. HEATER
120VAC, 60 Hz
12.5Amps
1500 Watts
LED
4. DOWN LIGHT
5. TIMER
Publicité
