Standard Backrest; Q.mono Back - IRIS Quickie Mode D'emploi

ENG LI S H
P. STANDARD BACKREST
50
1. Angle Adjustment
a. Loosen rear bolt (A).
b. Loosen and remove angle adjustment bolt (B).
c. Set backrest at desired angle using pre-set holes.
d. Replace and tighten the front bolt (B).
e. Tighten rear bolt (A).
f. Repeat on other side.
IMPORTANT NOTE– The adjustment on each side of the chair should be exactly equal.
NOTE– Use a torque setting of 240 in.-lbs. When setting-up the angle adjustment of the stroller handle.
NOTE–
Backrest position may also need adjusting to maintain optimal CG alignment and stability.
2. Flip-Down Back Function
a. To fold the back down, pull-up the back release pins (J) and push the backrest forward.
b. To lock it back in position, lift the backrest firmly until it locks in its original position.
3. Dynamic Backrest Elastomer Replacement
a. Remove socket head screw (C) and lock nut (D).
b. Using a flat head screw driver, gently pry out the elastomer (E) as shown.
c. Firmly press the new desired elastomer into place, and align holes in elastomer with holes in plate (F).
d. Replace and tighten screws removed above.
If the chair is equipped with the Dynamic Backrest option, the lockout feature must be in the locked position on
both push handles prior to any type of transport of the chair.
4. Dynamic Backrest Lock Engagement
a. Pull key ring (G) and swing lock downward to unlock backrest.
b. Swing lock upward to lock the backrest.
Q. MONO BACK
1. Backrest Height Adjustment
a. Using a 5/32" hex key, Loosen the 4 button head screws(H).
b. Grip the backshell and bracket assembly. It should move freely up or down the Mono back spine.
c. Set the backrest assembly to the preferred height.
d. Tighten all 4 of the button head screws (H).
NOTE– Use a torque setting of 60 in.-lbs. When setting-up the height adjustment of the Mono Back.
NOTE– Anytime the Backrest position changes, it is a good idea to verify that the optimal CG alignment and
stability is maintained.
113373 Rev. E
51
52
WARNING
53
54
IX. DEALER SERVICE & ADJUSTMENT
24
50
A
B
51
J
52
53
G
Unlocked
Locked
54