Publicité
Les langues disponibles
Les langues disponibles
BACHMANN EUROPE PLC
Installing a loud speaker
The railcar is already completely prepared
for locomotive sound operation. You can
plug in the sound decoder vertically on the
1-pin interface. To do this, please follow
the description under decoder Installation
above.
The loudspeaker ( Fig. 5 ) is intended to be
installed in the roof area under the air-
conditioning cover ( K ). This part is only
clicked into place on the roof. The air-con-
ditioning unit is easy to remove from the
roof and can be pulled off vertically. The
loudspeaker (d = 16 mm) can be clipped
into the mount ( M ). You can connect the
loudspeaker itself to two pins ( V ) soldered
on the circuit board.
Looking after your model
In order to ensure that your model functions correctly over a long period the railcar should
be maintained at regular intervals. The model need not be opened to do this. It is perfectly
sufficient to turn the model over on a soft base as shown in Fig. 6. Be careful not to da-
mage the roof parts or the pantographs. Clean the wheel contacts using cotton wool tabs
soaked in spirits and then clean the wheels. However, please do not turn the drive wheels
by hand in any circumstances. After cleaning please use a drop of machine oil to lubricate
the bearing points ( L ) shown in the figure. It is advisable to carry out maintenance work
after approximately 0-0 hours of operation.
H0 1:87
Betra_L133940_59_D_GB_F.indd 17
K
M
V
Figure 5
Figure 6 see next page
17
09.03.2011 10:12:40 Uhr
Publicité
