Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT SAFETY INSTRUCTIONS
1.
To disconnect heater, turn controls to off, then remove plug from outlet.
2.
A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
3.
Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury
to persons.
4.
Do not use this appliance on an extension lead.
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock and injury to persons. These
include the following:
Installation.
1.
Read all the instructions before using this heater.
2.
Do not locate this heater immediately below a socket outlet.
3.
Do not use this heater in the immediate surround of a bath, shower, or swimming pool. Do not allow any contact with water.
4.
Do not cover this heater. Do not locate near curtains etc, they could blow and cover the heater. Do not allow any flammable objects such as
chairs, tables etc to be placed within six feet of the heater. Do not allow anything to restrict the airflow around the heater, there could be a risk
of overheating.
5.
Do not lead the cable in front of the air outlet.
6.
Do not trap the cable. Ensure that the fire is not standing on the cable.
7.
Before use, the appliance must be securely fixed by the method described in the following pages. Until it has been fixed in place, do not leave
it in a location where it could be accidentally knocked over by children or pets etc.
8.
Do not permanently fix the appliance, it will need removing for servicing.
9.
Parts of this heater are hot when in use. To avoid burns, do not touch hot surfaces.
10.
Do not run the cable under a carpet or rug etc. Arrange cable away from traffic areas and where it will not be tripped over.
11.
This appliance must not be used by children or other persons without assistance or supervision if their physical, sensory or mental capabilities
prevent them from using it safely. Children must be supervised to ensure that they do not play with or touch the appliance. Use an approved
fixed fire screen or safety guard if there is any chance that the appliance could be inadvertently touched.
12.
Do not use outdoors.
13.
Do not operate any heater with a damaged cable or plug or after the heater malfunctions, or after it has been dropped or damaged in any man-
ner. Return the appliance to an authorised service agent for examination and repair.
14.
Do not insert or allow foreign objects to enter the appliance as this may cause electric shock, fire, or damage to the appliance.
15.
This is an imitation flame effect electric fire and must not be used as a real fire.
16.
Do not sit or put loads on top of the appliance.
17.
If moving, do not drag the appliance as this could cause damage. Lift the appliance (with help if required), move then lower.
18.
Risk of choking. The pebbles on the fire are real. Do not allow children or pets etc to eat the pebbles due to the risk of choking. Never leave
unsupervised.
19.
Switch off and unplug the appliance when not in use.
Save these instructions
Commissioning your fire / surround
Always wear protective gloves, boots, goggles and clothing when carrying out any fitting or servicing tasks on this appliance. Ensure
all tools are in good repair. If in any doubt, seek assistance.
Carefully unpack your electric fire, it will consist of: Electric fire, one spacer already fixed to frame, bag of coal, bag of
pebbles, bag of shells, a fixing kit and a remote handset. Model 547 also contains a bag of coloured marbles and a set of
coloured glass filters.
1. Position the electric fire following the installation instructions above. For stability you must fix the fire into position using
the fixing kit, this is to ensure that the appliance will not fall forward. Using the wall plug, attach the eye-bolt to the wall or
back of the fireplace behind the fire. Screw the fixing screws and washers partway into the hole shown in the diagram. Wrap
one end of the wire half way around the left-hand screw and tighten so the wire is trapped between the washer and the chas-
sis. Now pass the other end of the wire through the eye bolt. Move the fire closer to the eyebolt . It is not usually necessary
to have the wire taut. Thread the wire through one of the two fixing holes in the other side of the chassis, position the fire,
then pull through the wire to take up the slack and thread the wire all the way back through the other hole. Move the fire back
to the required position and check it is secured by tipping the fire forwards so the wire is supporting the weight. Give it a
small tug to ensure that it is secured.
2. The appliance comes with one removable spacer. If you would like to use the electric fire freestanding,
leave the spacer fixed to the rear of the front trim. If you have a suitably sized fireplace opening the spacer
can be removed to allow insetting.
3. (547 only) Coloured glass filters are provided to change the flame colour. Please chose the filter with the colour of your
choice and slide it over the light bulb. To gain access to the light bulb, see "maintenance, replacing the lamp" below.
4. Place the coal/pebbles/shells on the fibreglass fuel bed. If for any reason you need more pebbles, it is quite acceptable to
use normal pebbles, shells or washed coal.
INS531UR + 547UR Eng French Sept 06
Publicité
