Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility
of the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product
labels are lost or not legible, contact Tech for a free replacement. If the operator is not fluent in English, the product and safety
instructions shall be read to and discussed with the operator in the operator's native language by the purchaser/owner or his
designee, making sure that the operator comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of Portable Automotive Lifting Devices are subject to certain hazards that cannot be prevented by mechanical means, but
only by the exercise of intelligence, care, and common sense. It is essential to have personnel involved in the use and operation
of the device who are careful, competent, trained, and qualified in the safe operation of the device and its proper use when
servicing motor vehicles and their components. Examples of hazards are dropping, tipping or slipping of loads caused primarily
by improperly securing loads, overloading, off-centered loads, use on other than hard level surfaces, and using equipment for a
purpose for which it was not intended.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
Read, study, understand and follow all instructions before operating this device.
Inspect the jack before each use. Do not use jack if damaged, altered, modified, in poor condition, leaking hydraulic fluid,
or unstable due to loose or missing components. Make corrections before using.
Lift only on areas of the vehicle as specified by the vehicle manufacturer.
User and bystanders must wear eye protection.
Do not use jack beyond its rated capacity. Do not shock load.
This is a lifting device only. Immediately after lifting, support the vehicle with jack stands
capable of sustaining the load before working on the vehicle.
Use only on a hard level surface free from obstructions so the jack is free to reposition itself during lifting and lowering
operations.
Center load on saddle. Be sure setup is stable before working on vehicle.
Do not move or dolly the vehicle while on the jack.
Do not use any materials that may serve as risers, spacers or extenders between the stock lifting saddle and the load.
Do not use any adaptors that replace the stock lifting saddle unless approved or supplied by the jack manufacturer.
Do not use (or modify) this product for any other purpose than that for which it was designed without consulting the
manufacturer's authorized representative.
Always lower the jack slowly and carefully.
This product may contain one or more chemicals known to the State of California to cause cancer and birth defects or
other reproductive harm. Wash hands thoroughly after handling.
Failure to heed these warnings may result in fatal personal injury and/or property damage.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and not comply with them, and neglecting the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
TJ325LP
TJ325LP
3.25 TON CAPACITY
FLOOR JACK
WARNING
WARNING
1
WARNING: Indicates a hazardous
situation which, if not avoided, could
result in death or serious injury.
rev. 01/23/17

Publicité

loading

Sommaire des Matières pour TECH TJ325LP

  • Page 1 If the manual or product labels are lost or not legible, contact Tech for a free replacement. If the operator is not fluent in English, the product and safety instructions shall be read to and discussed with the operator in the operator’s native language by the purchaser/owner or his...
  • Page 2 Rotate the pump handle clockwise until it stops and proceed to pump the handle until the lift arm reaches maximum height. d. Repeat steps "A" through "C" until all air is purged from the system. IMPORTANT: Before attempting to raise any vehicle, check vehicle service manual for recommended lifting surfaces. TJ325LP rev. 01/23/17...
  • Page 3 ACTION: Purge air from hydraulic system as above or check oil level in reservoir. PROBLEM: HANDLE TENDS TO RAISE UP WHILE THE UNIT IS UNDER RATED LOAD. ACTION: Pump the handle rapidly several times to push oil past ball valves in power unit. TJ325LP rev. 01/23/17...
  • Page 4 Chassis Length ..............27.5 in Low Height Reach ............. 12.5 in Overall Width ............... 14 in Chassis Height ..............6.3 in Handle Length ..............50 in Saddle Diameter ..............4.6 in Net Weight ...............94.8 Lb Gross Weight ..............103.6 Lb TJ325LP rev. 01/23/17...
  • Page 5 TJ325LP 3.25 TON CAPACITY FLOOR JACK REPLACEMENT PARTS Item No. Part No. Description Qty. Item No. Part No. Description Qty. RS35T01 Star Clip RS35T11BK Handle Yoke Assembly RS35T02 Washer RS35T12 Grease Fitting RS35T03BK Front Wheel RS35T13 Handle Yoke Screw RS35T04...
  • Page 6 Si las etiquetas del manual o producto son ilegibles o no están en su lugar, deberá ponerse en contacto con Tech para obtenerlas gratis. El comprador/propietario o una persona designada deberá leer y comentar el producto y las advertencias de seguridad en la lengua materna del operario que no hable inglés fluido, a fin de asegurarse de que comprende el contenido.
  • Page 7 Gire el mango de la bomba en el sentido de las agujas del reloj hasta que se pare y proceda a bombear el mango hasta que el brazo de levantamiento alcance su máxima altura. d. Si la condición aparenta estar mejor, repita los pasos "A" al "C" hasta que se haya purgado todo el aire del sistema. TJ325LP rev. 01/23/17...
  • Page 8 PROBLEMA: EL MANGO TIENDE A ELEVARSE MIENTRAS QUE LA UNIDAD ESTÉ BAJO LA CARGA NOMINAL. ACCIÓN: Bombee el mango rápidamente varias veces para empujar el aceite más allá de las válvulas de bola en la unidad de potencia. TJ325LP rev. 01/23/17...
  • Page 9 Longitud del despeje bajo ......... 356 mm Anchura global ............356 mm Altura de chasis ............160 mm Longitud del mango ..........1270 mm Diámetro de la silla ..........116 mm Peso neto ..............43 Kg Peso bruto ..............47 Kg TJ325LP rev. 01/23/17...
  • Page 10 état et le ranger dans un endroit facilement accessible à tous ceux qui doivent le lire. Si le manuel ou les étiquettes de l'outil sont perdus ou illisibles, communiquer avec Tech pour obtenir un remplacement. Si l’utilisateur ne parle pas couramment le français, les consignes de sécurité...
  • Page 11 Si la pompe semble mieux réagir, répétez les étapes «A» à «C» jusqu'à avoir purgé l'air complètement du système. IMPORTANT: Avant de tenter de soulever un véhicule, consultez le manuel d'entretien pour les surfaces de levage recommandées. TJ325LP rev. 01/23/17...
  • Page 12 PROBLÈME: LE MANCHE À TENDANCE À SE SOULEVER LORSQUE L'UNITÉ PORTE LA CHARGE NOMINALE ACTION: Actionner le manche à plusieurs coups de pompe afin de pousser l'huile au-delà des soupapes à sphères dans le vérin de commande. TJ325LP rev. 01/23/17...
  • Page 13 Longueur de la faible garde au sol ......356 mm Largeur totale ............356 mm Hauteur du châssis........... 160 mm Longueur de manche ..........1270 mm Diamètre de la selle ..........116 mm Poids net ..............423 Kg Poids brut ............... 47Kg TJ325LP rev. 01/23/17...