BOMANN DB 777 CB Mode D'emploi page 24

Connected Wattage
The station has a total maximum wattage of 2200 W. With this
connected load a separate supply line protected by a 16 A
household circuit breaker is recommended.
CAUTION: OVERLOAD!
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this device is too
powerful.
Temperature Control on the Iron (5)
The symbols on the control correspond to the following settings:
MIN
Synthetics, nylon, acrylic,
●
rayon
● ● Wool, silk
● ● ●
Cotton, linen
MAX
Water Tank (3)
• Place the iron in an upright position.
• Fill the water reservoir at the refill opening (8). Use the filling
container to help you. Close the lid of the tank.
• The tank volume is 150 ml.
Water
Please use only distilled water.
Do not fill battery water, water from the clothes dryer and water
containing additives (such as starch, perfume, softener or other
chemicals) into the water reservoir.
This could damage the iron due to residues forming in the
steam chamber. These residues may cause impurities to the
fabric when dropping out of the holes in the soleplate.
Operation
Before Initial Use
• Clean the ironing base with a slightly damp cloth.
• In order to remove all residues before initial use, please
pass the iron a few times over an old clean cloth.
Ironing without steam
NOTE:
• Sort out the garments according to their ironing tempera-
tures.
• Always set the temperature control to "MIN" before
connecting the appliance to a power point, or before
disconnecting it.
• Set the steam regulator (9) to the tip of the wedge mark
(off).
24
• Place the iron on its stand.
• Only connect the machine to a properly installed safety
• Set the temperature on the temperature control (5). If you
The control lamp (2) on the iron shows that it is heating up.
As soon as the control lamp goes off the operating tempera-
ture has been reached. Now you can start ironing.
• Always turn the temperature control to "MIN" after use and
off
Steam Ironing
low temperature
The steam is hot. Danger of scalding!
medium temperature
high temperature
maximum temperature
• For this a high temperature is needed. Turn the tempera-
• If the temperature is too low water may leak from the
• Set the steam regulator (9) to the broad end of the wedge
• Steam escapes as soon as the iron is in a horizontal posi-
• Extra steam can be added with the steam jet function
• Press the steam jet button (10) intermittently.
Spray Function ( )
• In order to moisten a section of a garment to be ironed,
Vertical Steam function
This can be used to produce a jet of steam in a vertical direc-
tion.
Never direct the steam jet at people. Risk of burning!
• Hang your laundry on a clothes hanger and move the iron
• Press the steam jet button (10) intermittently.
Refilling the water tank
• Always disconnect the mains plug before refilling water.
• Set the steam regulator (9) to the tip of the wedge mark (off).
• Place the iron in an upright position.
• Open the lid of the refill inlet and carefully pour in the water.
• Do not exceed the maximum line as marked on the water
• Close the lid of the tank.
socket, 230 V/50 Hz.
have sensitive items to iron, please begin with the lowest
temperature.
NOTE:
remove the mains plug (The control lamp goes off).
WARNING:
NOTE:
ture control (5) at least to the "● ●" symbol.
soleplate.
mark.
tion.
press the spray button (11) intermittently.
WARNING:
to approximately 3-5 cm away.
reservoir.
.