Applying And Hardening The Uv Gel - Princess Nail Studio NS225-2F86 Mode D'emploi

Applying and hardening the UV gel

We recommend hardening your thumb separately.
3. Carefully fi le the sides of the nails until they
are straight and remove any visible "wings".
4. Repeat steps 1 to 3 for the remaining nails.
1. Using the brush, take a small amount of UV
gel and wipe one side of the brush off on the
jar edge.
2. Apply a thin layer of gel to the nail. Ensure
that there is approximately 1 mm of space to
the cuticle. Do not apply excessive pressure
so that the brush does not leave behind any
streaks! Then apply the gel across the junc-
tion between the nail tip and natural nail.
Important: Do not use too much gel, other-
wise the nail will not be able to harden com-
pletely!
3. Repeat this for each nail.
4. Activate the UV lamp on the back using the
On/Off switch.
5. Hold your nails under the light for approxi-
mately 3 minutes. The drying time may vary
depending on the nail type, the type of gel
used, and the amount of gel applied.
6. Reapply the gel and repeat the hardening
process two more times and then turn off the
device.
24