BEAUTY JATA MP423 Instructions D'usage page 13

Second step: THE BACK OF THE HEAD
Put in one of the two guides corresponding to the desired length of 6 or 9 mm. and cut the area at the back of
the head, identified as zone "B" in the figure.
Third step: SIDES
• Using the 3 or 6 mm. cutting guides, start cutting the side burns and the area close to the ears. Next, use the
guide corresponding to the cutting length 9 or 12 mm. to go on cutting the hair at the top of the head.
Fourth step: The top of the head
• Put in the guide corresponding to the longest cutting length (12 mm.) and start cutting from the crown forwards
against the growth of the hair. In some cases you will have to cut from the front backwards.
• To leave your hair longer use a comb to lift the hair at the back of the head and cut above the comb; or else hold
the lock of hair between your fingers and cut off the to the desired length.
• Always working your way from the back of the head, gradually cut the hair, shorter each time by reducing the
space between the comb or your fingers to the hair. Frequently comb your hair to check for any differences in its
length and to eliminate the hair which has already been cut.
Fifth step: THE FINAL TOUCHES
• Do not use any guides for the final touches.
• To get an exact haircut, and the side burns, nape and the area around the ears with straight lines, turn the hair
clippers round and place them at a straight angle with your head so the blade is in slight contact with the skin,
and shave downwards. This way you will get a perfect finish, as if shaving.
ADJUSTABLE LEVER
• You can use the adjustable lever for finished and retouched, specially round the neck and ears.
• To increase the cut distance put down the lever.
• To reduce the cut distance put up the lever.
TRIM THE BEARD
• Always remember you must begin with the longest cutting guide (12 mm.) before using one of the shorter
guides.
• Start by cutting from below the chin and moving the clipper with soft movements upwards and outwards.
• For the final touches and the edges always use the hair clipper without any guide.
REVISION OF MUSTACHE
• Comb the moustache downwards.
• Start with the higher cutting guide. Later you may use the shorter cutting guides.
MAINTENANCE AND CLEANING
• Before doing anything, make sure the clipper is unplugged from the mains.
• Use the brush to take off rests of hair in the blade.
• In case the blade has been dismantled for its replacement or cleaning, it must be adjusted again. To do so,
slacken lightly the screws placed at the bottom of the blade
• Use your fingers to move horizontally the blade until the ends are in perfectly aligned.
• The tooth of the up blade must be moved back 1, 2 mm. approximately, with regard to the tooth of the down
blade
• Use a slightly damp cloth to clean the outside of the appliance.
• Do not use in cleaning chemical products or abrasives, metallic scourers and similar, which may deteriorate the
surfaces.
ENVIRONMENT PROTECTION
• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the environment.
13