Publicité
Les langues disponibles
Les langues disponibles
Carefully inspect the carton for shipping damage. If any parts are missing or damaged, call your dealer.
A.
Do not attempt to install the appliance unless all parts are in good condition.
Correct installation is crucial to safe performance of your Outdoor Fire Pit.
B.
Due to high temperatures, the Fire Pit must be located out of traffic areas and away from combustibles.
C.
REPLACEMENT PARTS AND MEDIA ARE AVAILABLE THROUGH YOUR LOCAL DEALER
#1
Stainless Steel X-Burner
#2
Propane Regulator
#3
On/Off Control Knob
#4
Brass Control Valve
#5
Whisper Quiet Flex Line 22"
#6
Brass Fitting
#7
Propane Orifice
#8
Natural Gas Conversion Kit
#9
Protective Mesh Screen
PROTECTIVE SCREEN MEDIA PLACEMENT
Media placement is crucial to the operation of the fire pit performance.
To ensure proper air flow, the protective screen requires to be clear
of media on the surface and all four sides as shown above.
Electronic Igniter Battery Installation / Replacement Instructions
Remove the Electronic Igniter cap by turning counter-clockwise. Slide the AAA battery into the battery slot, make sure the positive side
of the battery faces outward. Replace the Electronic Igniter cap by turning the cap clock-wise until snug.
Electronic Igniter Cap
MEDIA PLACEMENT
#10 Thermocouple
#11 Electronic Igniter
#12 Spark Electrode
#13 Pebble Glass Kit – Size 3/4" – 1/2" (9-19mm)
#14 Crushed Fire Glass Kit –Size 1/2" – 3/4" (12-20 mm)
#15 Mirrored Glass Kit - Size 1/4" - (6.35mm)
#16 Lava Granules 3/8"
AAA Battery
Page 7
Minimum Clearance
Electronic Igniter
Publicité
