SCS Sentinel PSWM Manuel D'installation Et D'utilisation

DANGER OF ELECTROCUTION
Read carefully the following directions
Before the installing by the user of the power supply ref. PSWM, bellow called
« product or power supply », the consultation of these instructions is compulsory.
This product is not adapted for an external use. It must be mounted inside
an electrical and fire enclosure in self-extinguishing material. It must not
be used in different environmental conditions and work ranges than the
ones indicated on the label.
i To maintain class II product characteristic, respect the minimum distance (8
mm) between the primary and the secondary terminations and between
the primary terminations and any accessible metallic part. Before doing
the connection, make sure that the power was turned off. Before making
the installation, make sure the input clamps and the output clamps that are
identifiable through a special label placed on the upper part of the power
supply are correctly positioned. For the connections, use cables and
derivations with a section that does not exceed a current density of 4 A/
mm2 and add the right terminations. Make sure that all the terminal screws
are tightly fastened. Connect to the AC mains supply each input pole by a
readily accessible all-pole mains switch to provide a full disconnection under
the II overvoltage category.
PRECAUTIONS
(The negligence can cause death and serious injuries). Do not connect the
power supply with a not specified input source. Do not connect the output
clamps with the AC power source. Do not damage or crush the input wiring.
Do not effect connections with wet hands. Do not short-circuit the clamps or
the input and output wiring. Do not alter, open or perforate the power supply.
Keep the power supply and the AC wires away from moisture or dust.
CAUTIONS
(The negligence can cause injuries or damage the ownership). Do not install
or connect the power supply, while it is on: Electric shocks can occur and the
device can get damaged. Before turning on the power supply, make sure
that the wiring was not damaged or short-circuited. Flames or electric shocks
can occur.
PROHIBITIONS
Do never install this product in one of the following places: danger of malfunctions,
electric shocks or fire: Where not authorized and not qualified personnel
has access. Places that are exposed to very low temperatures, under direct
sunlight, near devices that temperature, in front of air conditioners, inside
a refrigerated area, etc... Places that are exposed to humidity or extreme
condensation, like bath rooms, cellars, greenhouses, etc... Places that are
exposed to specific environmental conditions, like dust, oil, chemicals, salt,
etc... Places exposed to continuous vibrations or impact. Places
exposed to warm stream or smoke (near heating equipments or cooking
surfaces). Outdoors or in the rain.
Manuel d'installation et d'utilisation
ALIMENTATION POUR MONTAGE EN COFFRET ELECTRIQUE
230 Vac 50-60 Hz / 12 Vdc -1 A
PSWM
DÉCLARATION DE GARANTIE
PAR COURRIER
PAR INTERNET
SCS SENTINEL - Service commande scs-laboutique.com
Rte de St Symphorien - BP 69
85130 Les Landes génusson (FRANCE)
MPF0202
V.04-2014 ::: Ind. A
FR
FR
Assistance téléphonique
au 0 892 350 490 (0.34 € TTC la minute)
horaire, voir sur le site internet
scs-laboutique.com