Publicité
PARTS AND FEATURES
REVERSIBLE DOOR
1.GLASS DOOR
2.LAMP SWITCH
3.USER INTERFACE
4.CABINET
5.CHROME WINE SHELVES
6.CHROME WINE SHELVES
7.FOOT
8.LED
The most energy-saving configuration
requires drawers, food box and shelves to be
positioned in the product, please refer to the
above pictures
Remark: above image is just for reference. The
actual configuration of the product may
change
INSTALLATION INSTRUCTIONS
Before Using Your Wine Cooler
• Remove the exterior and interior packing,
including protective foam on door panels.
• Before connecting the appliance to the
power source, let it stand upright for
approximately 2 hours. This will reduce the
possibility of a malfunction in the cooling
system from handling during transportation.
• Clean the interior surface with lukewarm
water using a soft cloth.
Installation of Your Wine Cooler
•
Place your appliance on a floor that is
strong enough to support the appliance
when it is fully loaded. To level your
appliance, adjust the legs at the front of
the appliance.
•
Allow 5 inches of space between the back
and sides of the appliance, which allows
the proper air circulation to cool the
compressor.
•
Locate the appliance away from direct
sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may
affect the acrylic coating and heat sources
may increase electrical consumption.
•
Extreme cold ambient temperatures may
also cause the appliance not to perform
properly.
•
Avoid locating the appliance in moist
areas. Too much moisture in the air will
cause frost to form quickly on the
evaporator.
•
Plug the appliance into an exclusive
properly installed-grounded wall outlet.
Do not under any circumstances cut or
remove the third (ground) prong from the
power cord.
•
Any questions concerning power and or
grounding should be directed toward a
certified electrician or an authorized
products service center.
Warning: Improper use of the grounded plug
can result in the risk of electrical shock. If the
power cord is damaged, have it replaced by
an authorized products service center.
EXTERNAL HANDLE
If the external handle is presented in the
product, follow the below steps for assembly.
26
Publicité
