Pco WPM 2006 plus Notice De Montage Et De Mise En Service page 40

11.3 Drying of Screed Floors ...............................................................................................................................................................E-32
11.3.1 General Information............................................................................................................................................................. E-32
11.3.2 Standard Program for Screed Drying ..................................................................................................................................E-33
11.3.3 Individual Program for Screed Drying .................................................................................................................................E-33
12 Extended Installation Instructions for the Heat Pump Manager (Heating/Cooling)................................E-34
12.1 Heating and Cooling Controller....................................................................................................................................................E-34
12.1.1 Network Operation of Heating and Cooling Controllers and Remote Control .....................................................................E-34
12.1.2 Temperature Sensor (Cooling Controller) ...........................................................................................................................E-34
12.2.1 Heat Pumps without Additional Heat Exchangers...............................................................................................................E-35
12.2.2 Heat Pumps with Additional Heat Exchangers for Waste Heat Recovery...........................................................................E-35
12.3 Cold Generation via Passive Cooling ..........................................................................................................................................E-35
12.4.1 Cooling Operating Mode ..................................................................................................................................................... E-35
12.4.2 Activation of Cooling Functions ...........................................................................................................................................E-36
12.4.3 Deactivation of Circulating Pumps in Cooling Operation.....................................................................................................E-36
12.4.4 Silent and Dynamic Cooling ................................................................................................................................................E-36
12.5 Regulation of the Room Temperature .........................................................................................................................................E-36
13.1 Remote Control............................................................................................................................................................................E-37
13.2 Remote Diagnostic System (FDS)..............................................................................................................................................E-37
13.3 Room Climate Control Station ..................................................................................................................................................... E-37
Anhang / Appendix / Annexes .............................................................................................................................A-I
E-2