Witter SA15AU Instructions De Montage

MATERIALS
A 1 Cross Bar with European
D 4 M12 x 35 x 1.75 Bolts, Lock Washers and Flat Washers (25mm O.D). and Special Nut Retainers
With Square T nuts.
ZE 1 Electrical Plate (ZEP2)
FITTING
1. Remove Bumper.
ALTEA: (5 tip screws in each wheel arch, top tip screw is hidden below trim, 8 tip screws along bottom edge of bumper, 2 tip
screws under each light cluster. (To remove light cluster, remove small panel on inner trim and undo large plastic nut on back of
light, remove 2 tip screws through plastic trim to inner side and slide light cluster rearward). Disconnect fog lamps, reversing light
and reversing sensors (if present) and slide bumper rearward.
TOLEDO: (5 tip screws in each wheel arch, top tip screw is hidden below trim, 7 tip screws along bottom edge of bumper, 2 tip
screws under each light cluster. (To remove light cluster, remove small panel on inner trim and undo large plastic nut on back of
light, remove 2 tip screws through plastic trim to inner side and slide light cluster rearward). Disconnect fog lamps, reversing light
and reversing sensors (if present) and slide bumper rearward.
LEON: (4 tip screws in each wheel arch, top tip screw is hidden below trim, 7 tip screws along bottom edge of bumper, 3 tip
screws under each light cluster. (To remove light cluster, remove small panel on inner trim and undo large plastic nut on back of
light, remove 2 tip screws through plastic trim to inner side and slide light cluster rearward). Disconnect fog lamps, reversing light
and reversing sensors (if present) and pull bumper edges outward.
2. Remove crash beam and refit bolts into back panel to prevent ingress of water. Hand crash beam to final user for refit when
bar is removed.
3. Insert towbar (with cage nuts fitted) (A) into chassis rails and attach using bolts (D) in position shown. Note holes in chassis
side may be hidden under tape.
4. Attach Detachable Housing (ZQ) and Electrical Plate (ZE) as per separate Instruction.
5. Cut bumper as shown and refit, it is advisable to protect bumper around neck area whilst refitting.
Note:
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
Fitting
Instructions
W0001SA15AU-FIT$010802220000(Ä
W 0001SA15AU-FIT$010802220000
Seat Altea 2004 –
Seat Toledo 2004 –
Seat Leon 2005 –
For use with 2031 series Necks.
TOWBAR
SA15AU
For