Feit Electric T848/830/LEDG2/2 Guide D'installation

ITEM# T848/830/LEDG2/2
INSTALLATION GUIDE FOR T8 TYPE A
This LED tube is intended to replace fluorescent tube lamps with ANSI designation 32W/48T8/RS, 32W/48T8
THIS PRODUCT MAY NOT BE COMPATIBLE WITH ALL BALLAST. FOR MORE INFORMATION ABOUT BALLAST
COMPATIBLITY PLEASE VISIT WWW.FEIT.COM
PLEASE REVIEW THE INSTRUCTIONS AND WARNINGS LISTED BELOW PRIOR TO PROPER INSTALLATION
WARNINGS
• Risk of fire / electrical shock
• LED Tube installation requires knowledge of luminaire electrical systems.
• Risk of electric shock – disconnect power at source before installation
• Do not make or alter any open holes in an enclosure of wiring or
electrical components during installation.
• If lamp or luminaire exhibits abnormal operation (buzzing, flickering,
minimal light, etc.), turn off power, remove lamp and contact us. For
more information please visit www.feit.com
DIRECT REPLACEMENT/PLUG & PLAY INSTALLATION INSTRUCTIONS (TYPE A)
STEP 1 .
Turn- off power before installation
SAVE THESE INSTRUCTIONS
STEP 2 .
Replace fluorescent tube with Feit LED Tube
A
Open difuser cover
for access.
B
Rotate fluorescent tube to remove then insert new LED tube and rotate to
lock into place. Repeat sequence for each tube. Close cover when complete.
FEIT ELECTRIC COMPANY | PICO RIVERA, CA | (800) 543-3348 | FAX (562) 908-6360 | www.feit.com
CAUTION
• Do not use with dimmers.
• Do not look directly at the operating LED Tube.
• Do not touch this product with wet hands.
• Do not disassemble, repair or alter lamp.
• Designed for indoor applications only.
• The luminaires shall be grounded.
• Be careful not to touch the lamp pins to the metal housing
when installing.
• This device is not intended for use with emergency exits or
emergency lights.
STEP 3 .
Turn-on power and enjoy new
Feit LED Tube