ROMMER FV 355 Notice D'utilisation page 12

3 USING THE APPLIANCE
3.1 Information on Less Frost
Technology
Thanks to the wrap around evaporator,
Less Frost technology offers more efficient
cooling, less manual defrost requirement,
and more flexible storage room.
3.2 Thermostat Setting
The thermostat automatically regulates
the temperature inside the refrigerator and
freezer compartments. Cooler temperatures
can be obtained by rotating the knob to
higher numbers, 1 to 5 and SF.
Lamp cover
Thermostat Settings
• Set the knob to a low/medium position,
up to 3, for short-term storage of food in
the appliance.
• Set the knob to a medium position, 3 or
4, for long-term storage of food in the
appliance.
• Set the knob to 5 for frequent use of fresh
food and freezer compartments in hot
ambient temperatures.
• Turn the knob to SF to freeze fresh
food quickly. In this position, the freezer
compartment will operate at lower
temperatures. After your food freezes,
turn the thermostat knob to its normal
use position. If you do not change the
SF position, your appliance work will
automatically return to its last used
thermostat position after 48 hours. Return
the thermostat switch to the SF position
and return it to normal use 48 hours later.
Thermostat knob
EN - 12
Important note: If the thermostat
switch is in the SF position when your
appliance is first started, your appliance
work will automatically return to the
operation in the thermostat-3 position 48
hours later after starting.
3.3 Temperature Settings Warnings
• The ambient temperature, temperature of
the freshly stored food and how often the
door is opened affects the temperature in
the refrigerator compartment. If required,
change the temperature setting.
• It is not recommended that you operate
your fridge in environments colder than
10°C in terms of its efficiency.
• When setting the thermostat, take into
consideration how often the appliance
doors are opened and closed, how much
food is stored in the refrigerator, and the
environment in which the refrigerator is
located.
• When the appliance is first switched on,
allow it to run for 24 hours in order to
reach operating temperature. During this
time, do not open the door and do not
keep a large quantity of food inside.
• Unplug your appliance during a power cut
to prevent damage to the compressor.
Once power is restored, delay plugging
in your appliance for 5 to 10 minutes.
This will help prevent damage to the
appliance's components.
• Your appliance is designed to operate in
the ambient temperature ranges stated
in the standards, according to the climate
class stated in the information label. It
is not recommended that your fridge is
operated in the environments which are
outside of the stated temperature ranges.
This will reduce the cooling efficiency of
the appliance.