→
Relais statique synchrone spécialement adapté aux charges résistives (AC-1).
Livré monté sur dissipateur WF151200 avec adaptateur rail DIN.
Zero Cross Solid State Relay especially designed for resistive loads (AC-1).
Delivered mounted on WF151200 heatsink with DIN rail adaptor.
→ Sortie thyristors technologie TMS
12 à 280VAC 40A max. 28A @ 40°C / 33,5A @ 20°C suivant courbe page 3.
Back to back thyristors on output with TMS
expectancy : 12 to 280VAC max 40A. 28A @ 40°C / 33.5A @ 20°C in air calm
according thermal curve page 3.
→ Protection contre les surtensions en sortie par amorçage des thyristors
(diodes transils sur les gâchettes)
Overvoltage protection at the output by self turn ON of the thyristors
(TVS diodes on gates)
→ Large plage de contrôle: 3-32VDC avec un courant de commande régulé.
LED de visualisation sur l'entrée de couleur verte.
Protection aux surtensions sur l'entrée intégrée.
Large control range: 3-32VDC with input current limiter.
Green LED visualization on the input.
Input overvoltage protection.
→ Connecteurs de puissance ressort type "push-in" doublés (6mm² max)
Double "push-in" type spring power terminals (max. 6mm²)
→ Connecteurs de commande ressort débrochable type "push-in" doublés (2,5mm² max)
Double "push-in" type pluggable spring control terminals (max. 2.5mm²)
→ Construit en conformité aux normes IEC/EN60947-4-3; IEC 60335-1/ VDE0700-1; IEC 62314
Designed in conformity with IEC/ EN60947-4-3; IEC 60335-1/ VDE0700-1; IEC 62314
Dimensions (mm)
2
(*) TMS
=Thermo Mechanical Stress Solution
Proud to serve you
All technical caracteristics are subject to change without previous notice.
Caractéristiques sujettes à modifications sans préavis.
okpac
Relais statique monophasé de puissance
raccordement "push-in"
Single phase Power Solid State Relay
with "push-in" terminals
2(*)
permettant une longue durée de vie :
2 (*)
technology with a long lifetime
1/L1
2/T1
LED
4/A2-
3/A1+
®
1/L1 et 2/T1 peuvent être inversés
1/L1 and 2/T1 can be swapped
Le relais doit être monté sur
dissipateur thermique.
SSR must be mounted on heatsink
Application typique:
Résistance 12 kW (Catégorie AC-1) en 400VAC
Typical application:
12 kW resistor (AC-1 load) on 400 VAC
celduc
r
e
S/SOR943440-HE-WF151/A/30/11/2023
page 1 / 6F/GB
SOR943440-HE
-WF151
Output : 12-280VAC 35A
Input : 3-32VDC
l
a
i
s
Secteur AC /
AC Mains
Charge /
Load
Heater
®