VONMÄHLEN AIR BEATS Mode D'emploi page 16

LED-STATUS
Power on
Power off
Bluetooth
® pairing
Connected to Bluetooth
Wired Music
TWS Connection Setup
Establishing TWS connection
between two speakers
Establish TWS connection
to a device
Low battery
Charging
Resetting-Mode
If the speaker does not work properly, it should be reset to the factory settings. Press and hold the
reset button in the 3.5 mm audio jack of the unit for 3 seconds using a toothpick or paper clip.
16
The white LED flashes.
The LED is off.
The blue LED flashes.
The white LED is on.
®
The white LED is on.
The LEDs of both speakers flash blue during
connection setup.
The blue LED of the main speaker pulsates.
The blue LED of the secondary speaker lights
up continually.
The LEDs of both speakers light up blue.
The red LED flashes slowly. The speaker automatically
reduces the volume during playback.
The red LED is on during charging.
The red LED turns off when charging is finished.