Star Ultra Max UM1850A Instructions D'installation Et De Fonctionnement page 14

Removing Finger Assemblies
1. Once cooled, REMOVE conveyor assembly and door.
2. Life up and remove Upper & Lower Baffles as shown in Step 1.
3. Slide Finger Assembly out of unit as shown in Step 2.
4. Lift Assembly apart as shown in Step 3. and wash in a hot water, detergent mix and rinse
with clean water.
cleaner.
Reassemble Finger Assemblies
1. Reassemble finger assemblies and install in unit.
2. Properly install Baffles as shown in Step 4.
CAUTION
BE CERTAIN THE LOWER BAFFLE IS PROPERLY INSTALLED BEHIND THE REAR PANEL
SO NOT TO INTERFERE OR DAMAGE CONVEYOR ASSEMBLY.
3. Reinstall conveyor & door assembly, and test unit for proper operation.
1
LOWER BAFFLE
For difficult cleaning areas, use a heavy-duty de-greaser or oven
2
4
Baffle & Finger Removal / Installation
12
3
UPPER BAFFLE
IL1190