Publicité
INSTALLATION INSTRUCTIONS
STEP 1
Install the provided brackets to building
structure using screws (not provided). For
spacing, please refer to Fig. 2 on page 1.
¼" KNOCKOUT
STEP 4
Remove (2) ¼" knockout from the housing
to insert (2x) #10-24 Machine screws
provided.
STEP 6
Mount housing through the cutout in the ceiling. Ensure the screws are attached to the
bracket via the provided Washer & Cage Nut. Review figure 1.
Page 2/2 Rev. 06/09/16
© 2016 Columbia Lighting, a division of Hubbell Lighting, Inc. Because of continuing product improvement programs, Columbia Lighting reserves the right to change
specifications without notice. 701 Millennium Blvd. Greenville, SC 29607 / Tel 864.678.1000 / Tech Support 864.678.1668 / Website www.columbialighting.com
Specification Grade Contemporary Wall Wash/Technical Installation Data
STEP 2
Create a cutout in the ceiling based on the
following dimensions.
23 ½" x 3 ¾" (FOR 2' Version)
47 ½" x 3 ¾" (FOR 4' Version)
STEP 5
Open access plate to splice power wires to fixture wires. Remove the knockout to connect
conduit to access plate. Connect green wires to ground screw on access plate. Connect
incoming power lines to fixture with provided disconnects.
Secure access plate to the fixture.
CWW
STEP 3
To Install (2x) 10-24 Machine Screws onto
the fixture:
I. Remove the lens on the fixture using a
flat head screw driver.
II. Second, using a Philips screw driver
remove #6 screws to uninstall the LED
tray and disconnect the wires Red (+)
and Blue (-) from the driver.
SUPPLY
GROUND
STEP 7
Once the housing is securely attached to
the brackets, reinstall the LED tray.
To ensure the lens is mounted in the right
direction, orient the lens such that the
taller side of the lens is aligned with the
dimples on the housing.
LED / CWW
Publicité
