ETRONIX EX6G Mode D'emploi page 2

FAMILIARIZING YOURSELF WITH YOUR 2.4GHZ RADIO SYSTEM
SYSTEM FEATURES
• 2.4ghz FHSS
• Receiver 3mS response time
• 400-500m range
• Failsafe feature
• Transmitter voltage range 6V-7.4V
(support 1s-2s) automatic
indentification of voltage, low voltage
warning: 7.4V/4.8V
• Receiver voltage range: 3.3V-7.4V,
working current 30mA, supports high
voltage servos.
• Channels 5 & 6 for crawler accessories
with a press lock/release function.
SIMULATOR/
PPM INTERFACE
BINDING LED BUTTON
TRANSMITTER BATTERY INSTALLATION
1. Press down on the battery cover and slide in the direction of the arrow to remove.
2. Install 4 AA alkaline cells (or Ni-Cd, or Ni-MH) as indicated inside the battery compartment.
Make sure to match the inside polarity the (+ and -) as shown in the battery compartment or the
transmitter will not function.
3. Install the battery cover in place and slide to close.
WARNING:
IMPROPER INSTALLATION OF TRANSMITTER BATTERIES CAN CAUSE SERIOUS DAMAGE TO YOUR SYSTEM.
MENU SETTING:
To enter the program mode:
1. With the power off, turn the steering wheel (Ch1) back
(anticlockwise) the maximum amount, at the same time
2. pull the trigger (Ch2) back fully.
3. Turn on the transmitter, (4) release the wheel and trigger
and (5) press the Ch3 button.
The LED indicator will now flash blue rapidly, indicating that
you have entered program mode.
Etronix EX6G Manual.indd 2 Etronix EX6G Manual.indd 2
All manuals and user guides at all-guides.com
STEERING REVERSE SWITCH (CH 1)
THROTTLE REVERSE SWITCH (CH 2)
STEERING TRIM DIAL (CH 1)
THROTTLE TRIM DIAL (CH 2)
STEERING
DUAL/RATE DIAL (CH 1)
THROTTLE DUAL/RATE DIAL (CH 2)
LED LIGHT
OPTIONAL CHANNEL (CH 4)
USB CONNECTION
(ONLY FOR UP TO
5V MAX)
BINDING PROCESS
1. Press the receiver button and the LED indicator will flash fast indicating it is entering bind mode.
2. Turn on transmitter. The receiver will automatically look for the nearest transmitter signal.
3. Once binding is successful the LED will stop flashing and remain on.
LED LIGHT
1. Normal use: blue light flashes slowly.
2. Mixed direction for Tank mode: Red light is always on.
3. Low voltage warning: Yellow light flashes slowly.
4. Entering second menu level mode: Blue/Red light flashes
quickly.
3. TURN ON
2
CHANNEL 6
CHANNEL 5
ON/OFF
THROTTLE (CH 2)
CHANNEL 3
INTERNAL BATTERY
SOCKET FOR 2S LI-PO.
1. TURN THE WHEEL
FULLY ANTI-CLOCKWISE
2. PULL THE TRIGGER
ALL THE WAY BACK
ANTENNA
STEERING WHEEL (CH 1)
BATTERY
COMPARTMENT
4. RELEASE THE
WHEEL AND TRIGGER
5. PRESS THE
3RD CHANNEL
19/06/2020 15:24 19/06/2020 15:24