Westfalia AFM18 Mode D'emploi page 26

Notes about Battery Charging
 The battery should be charged at ambient temperatures between
10° C and 40° C (ideally around 20° C).
 After charging, allow 15 minutes for the battery to cool before use.
 Ensure that the charger is disconnected from the mains supply after
use, and is stored correctly.
 Do not leave batteries on charge for extended periods and never
store batteries on charge.
 The battery charger monitors battery temperature and voltage while
charging. Remove the battery once charging has been completed to
maximise charge cycles of the battery and not waste power.
 Batteries can become faulty over time, individual cells in the battery
can fail and the battery could short. The charger will not charge
faulty batteries. Use another battery, if possible, to check correct
functionality of the charger and purchase a replacement battery if a
faulty battery is indicated.
 Do not store Lithium-Ion battery packs in a discharged state long
term. This can damage the Lithium-Ion cells. For long-term storage,
store batteries in a high charge state disconnected from the power
tool.
 The capacity of batteries will reduce over time. After 100 charge
cycles, the battery's operation time and the maximum torque per-
formance of the tool will slightly reduce. This decline will continue
until the battery has minimal capacity after 500 charge cycles. This
is normal and not a fault with the battery pack.
Inserting the Agitator
Always remove the battery before inserting or exchanging the agitator.
The mixer is equipped with a M 14 collet.
1. Screw the quick coupler (2) onto the shaft (3) by turning counter
clockwise.
2. Fix it by using the 2 supplied open-end spanners. Turn the
spanners to each other so that the quick coupler is firmly fixed in
the tool carrier.
Operation
22