Hama CCD 514L Mode D'emploi page 6

7. Always switch the shredder off (or remove
the mains plug) before moving or cleaning the
shredder or emptying the paper basket.
8. Empty the paper basket regularly.
PAPER BLOCKAGE AND OVERLOAD PROTECTION:
The CCD 514L has a motor with an overload protection
function. The normal operating cycle for uninterrupted
shredding activity is 3 minutes continuous operation
followed by 25 minutes switched off. The shredder
may switch itself off automatically in the following
cases:
1. If the shredder is used for more than three
minutes at a time.
2. If it becomes overloaded due to more than
fi ve sheets of paper being fed into the
shredder at a time, or if the paper is not fed
into the shredder evenly.
3. For your own safety, if the paper basket is
removed while the shredder is running.
The fi rst two cases can trigger the automatic overload
protection function which interrupts the power supply.
If this is the case, proceed as follows:
1. Remove the plug from the socket and wait
at least 25 minutes until the overload
prevention function resets. Remove all
remaining paper from the shredder or cut it off
appropriately.
2. Then connect the machine to the mains again
and set the switch to REV. Using the reverse
function, pull the paper trapped in the cutting
rollers out of the top of the shredder. You can
then set the switch back to AUTO.
3. If the switch is set to „AUTO" and the paper
feeder is clear, the shredder is now ready to
use again.
All manuals and user guides at all-guides.com
CLEANING AND CARING FOR THE CCD 514L:
This shredder requires regular care (monthly
for normal use). You should also oil the slitting
mechanism. If you do not do this, the motor noise can
become louder, blockages can occur more frequently,
the slitting capacity can decrease or it might not work
any longer.
Proceed as follows to oil the slitting mechanism:
1. Apply the appropriate oil to the rollers below
2. Set the switch to AUTO and let the rollers
3. Then set the switch to REV and let the
4. Repeat steps 2 and 3 about three more times.
TECHNICAL DETAILS:
- Cut sizes:
- Max. cutting capacity - paper: 5 sheets
- Max. cutting capacity - CD/plastic cards: 1 piece each
- Max. shred speed: 3.0 m/min.
- Max. feed width - paper: 220 mm
- Max. feed width - CD/cards: 150 mm
- Mains connection: 220-240 V~
- Dimensions of the CCD 514 L: 310x205x347 mm
the paper feed.
rotate for approx. 3 seconds.
shredder run for another 3 seconds.
- Paper: 4x35 mm (cross-cut)
- CD: 40 mm (strip-cut)
- Plastic card: 40 mm (strip-cut)
5