Télécharger Imprimer la page

Russell Hobbs 22280-56 Slice and Go Mode D'emploi page 4

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
Read the instructions, keep them safe, pass them on if you pass the appliance on. Remove all packaging
before use.
IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
This appliance can be used by persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been
supervised/instructed and understand the hazards involved.
Children must not use or play with the appliance.
Keep the appliance and cable out of reach of children.
C Misuse of the appliance may cause injury.
Unplug the appliance before assembly, disassembly, or cleaning.
Don't leave the appliance unattended while plugged in.
If the cable is damaged, it must be replaced by the manufacturer, its
service agent, or someone similarly qualified, to avoid hazard.
Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
b
Don't use fingers or cutlery to push food down the tube – only the pusher.
Don't use the appliance for any purpose other than those described in these instructions.
Don't operate the appliance if it's damaged or malfunctions.
Don't run the motor continuously for more than 2 minutes, it may overheat. After 2 minutes switch
off for at least 2 minutes, to recover.
PARTS
1.
Tab
2.
Slots
3.
Cutters
4.
Slicer
5.
Coarse grater
6.
Fine grater
7.
Ring nut
8.
Bayonet fitting
9.
Cutter mount
ASSEMBLY
1.
Switch the appliance off (O) and unplug it.
2.
Choose the pair of cutters you need – slicer, coarse grater, fine grater.
3.
Stand the cutter mount upright on the work surface. Don't try to fit the cutters to the cutter mount
while holding it in the operating position or you might cut yourself.
4.
Fit the tabs on the wide end of the cutter into the slots in the wide end of the cutter mount.
5.
Press the tab on the narrow end of the cutter into the space in the narrow end of the cutter mount.
6.
Turn the cutter mount, then fit the second cutter.
7.
Slide the cutter mount into the body.
8.
Turn the ring nut 45° clockwise.
9.
Push it on to the front of the body.
10. Turn it 45° anti-clockwise, to lock it in place.
HOUSEHOLD USE ONLY
10. Body
11. Tube
12. Guides
13.
Pusher
14. Cap
15. Switch
16. Motor unit
` Dishwasher safe
3
GB
DE
FR
NL
IT
ES
PT
DK
SE
NO
FI
RU
CZ
SK
PL
HR
SI
GR
HU
TR
RO
BG
AE

Publicité

loading